Skip to main content

CL11 Centreboard dimensions

 Was asked to share this with a fellow owner, and have posted here.








Comments

Post a Comment

Popular posts from this blog

Centreboard Replacement - From Compost to Completion. DONE!

DONE Many thanks to the kind members of the UK Gull facebook group for their encouragement and for providing the missing details required to replicate Ingrid's centreboard.  Compost Some photos of Ingrid's centreboard as received.   A large section was missing and what was left was crumbling. This hole is bored though the trailing edge of the centreboard, it received a locking pin which secured the board in the retracted position for trailering or beaching.   Photos of a UK-based Gull centreboard, detailing the missing section.  (Thanks Simon!) The photo and discussion also explained the mysterious bit of hardware in a box of stuff included with the boat.  This is an adjustable friction brake that fits in the slot at the top of the board.   It compresses 1” od rubber heater hose enough to span the centreboard case, resisting the board's swing.  Trial fit and hole marking. As with the pivot bolt reinforcements in the trunk, I decided to m...
2 comments
Read more

Stem and Transom fittings

 Ingrid had very few places to which to tie anything, and I noted as I scanned the internet that later boats and gulls had added some fittings for this purpose.   I added some stout fittings adequate to secure the boat to both dock and trailer. The transom was straightforward however the stem required the installation of  a fitted oak reinforcement , well bedded in glass-filled epoxy putty and then reinforced with two layers of 1708, making a solid stem post integrated with the fiberglass topsides.     
Post a Comment
Read more

Sails and Sailplan

Sailmakers, I am looking for price and delivery on the following: Cl-11/Gull Dinghy    (Ian Proctor design)   1    Mainsail luff 14'8", foot 6.9"   please specify roach/battens one row reef points at approximately 28" from tack, rising to 31" at clew,  cunningham cringle. Loose footed 2      Jib  8' 6.5", 7' 4.5", 4'2"  See photos for luff attachment as built  3 plastic hanks. Can a larger jib be made and still utilize the sheet leads? 3      Spinnaker    10'2" luffs, 11' foot.  or nearest stock size if it exists, Miscellaneous information: Measured dimensions of existing sails, grommet to grommet are: Main:   14'6", 16'2", 6'9"    No reef points, rope foot and luff, three battens) Jib:  8' 6.5", 7' 4.5", 4'2"  See photos for luff attachment as built  3 plastic hanks. Spinnaker   10'2" luffs, 11' foot.  or nearest stock size if i...
Post a Comment
Read more